TB 9-2320-280-35-9
NOTE
Remove right rear side rail, if necessary. (Refer to
TM 9-2320-280-20.)
Rear edge of upper mounting plate should be approximately
1.187 in. from front edge of EPLRS mounting plate.
15-3. Locate screw (10) on right rear wheelwell (7) and drill out rivet (9) from right rear
wheelwell (7). Enlarge hole to 0.281 in.
15-4. Position support plate underneath wheelwell and drill two 0.281-in. diameter holes.
15-5. Using upper antenna plate (6) as
template, locate, mark, and drill thirteen 0.281-in. holes (8) and
three 0.408-in. holes (11) in left rear wheelwell (7).
6
7
11
~
9.75
9
10
8
Figure 5-32.
5-26