TM 11-6130-227-40P-1
SECTION I
INTRODUCTION
Code
Definition
1. Scope
PA- Item procured and stocked for anticipated or
This manual lists spares and repair parts: special
known usage.
tools special test, measurement, and diagnostic
XB - Item is not procured or stocked. If not avail-
equipment (TMDE), and other special support equip-
able through salvage, requisition.
ment required for performance of general support
NOTE
maintenance of the PP-1660A/G and PP-1060B/G. It
authorizes the requisitioning and issue of spares and
Cannibalization or salvage may be used as a
repair parts as indicated by the source and mainte-
source of supply for an y items source coded
nance codes.
above except those coded XA and aircraft
support items as restricted by AR 700-42.
2. General
(2) Maintenace code. Maintenance codes are
assigned to indicate the levels of maintenance
This Repair Parts and Special Tools List is divided
authorized to USE and REPAIR support items. The
into the following sections:
maintenance codes are entered in the third and
a. Section II. Repair Parts List. A list of spares
fourth positions of the Uniform SMR Code format as
and repair parts authorized for use in the perform-
follows:
ance of maintenance. The list also includes parts
(a) The maintenance code entered in the
which must be removed for replacement of the
third position will indicate the lowest maintenance
authorized parts. Parts lists are composed of func-
level authorized to remove, replace, and use the sup-
tional groups in numeric sequence, with the parts in
port item. The maintenance code entered in the
each group listed in figure and item number
third position will indicate one of the following
sequence.
levels of maintenance:
b. Section III. Special Tools List. Not applicable.
Code
Application/Explanation
-
O-Support item is removed, replaced, used at
Number Index. A list, in National item identification
the organizational level.
number (NIIN) sequence, of all National stock
H-Support item is removed, replaced, used at
numbers (NSN) appearing in the listings, followed
the general support level.
by a list, in alphameric sequence, of all part numbers
(b) The maintenance code entered in the
appearing in the listings. National stock numbers
fourth position indicates whether the item is to be
and part numbers are cros-referenced to each illus-
repaired and identifies the lowest maintenance level
tration figure and item number appearance.
with the capability to perform complete repair (i.e.,
all authorized maintenance functions). This position
3. Explanation of Columns
will contain one of the following maintenance codes:
a. Illustrations. This column is divided as follows:
Application/Explanation
(1) Figure number. Indicates the figure number
Z - Nonreparable. No repair is authorized.
of the illustration on which the item is shown.
(3) Recoverability code. Recoverability codes
(2) Item number. The number used to identify
are assigned to support items to indicate the disposi-
item called out in the illustration.
tion action on unserviceable items. The recoverabil-
b. Source, Maintenance,
and Recoverability
ity code is entered in the fifth position of the
(SMR) Codes.
Uniform SMR Code format as follows:
(1) Source code. Source codes indicate the man-
Recoverability
ner of acquiring support items for maintenance,
Code
Definition
repair, or overhaul of end items. Source codes are
Z- Nonreparable item. When unserviceable, con-
entered in the first and second positions of the
demn and dispose at the level indicated in
Uniform SMR Code format as follows:
position 3.
1
