TM 116130-351-24P
SECTION I
INTRODUCTION
Code
Definition
1. Scope
PD-
Support item, excluding support equipment,
This manual lists spares and repair parts; special tools;
procured for initial issue or outfitting and
special test, measurement, and diagnostic equipment
stocked only for subsequent or additional initial
(TMDE), and other special support equipment required
issues or outfittings. Not subject to automatic
for performance of organizational, direct support, and
replenishment.
general support maintenance of the PP-6241/U. It
XA-
Item is not procured or stocked because the
authorizes the requisitioning and issue of spares and
requirements for the item will result in the
repair parts as indicated by the source and maintenance
replacement of the next higher assembly.
codes.
XB-
Item is not procured or stocked.
If not
available through salvage, requisition.
2. General
This Repair Parts and Special Tools List is divided into
NOTE
the following sections:
Cannibalization or salvage may be
a. Section II. Repair Parts List. A list of spares
used as a source of supply for any
and repair parts authorized for use in the performance of
items source coded above except
maintenance. The list also includes parts which must be
those coded XA and aircraft support
removed for replacement of the authorized parts. Parts
items as restricted by AR 700-42.
lists are composed of functional groups in numeric
sequence, with the parts in each group listed in figure
(2) Maintenance code. Maintenance codes
and item number sequence.
are assigned to indicate the levels of maintenance
b. Section III. Special Tools List. Not applicable.
authorized to USE and REPAIR support items. The
c. Section IV. National Stock Number and Part
maintenance codes are entered in the third and fourth
Number Index. A list, in National item identification
positions of the Uniform SMR Code format as follows:
number (NIIN) sequence, of all National stock numbers
(a) The maintenance code entered in the
(NSN) appearing in the listings, followed by a list, in
third position will indicate the lowest maintenance level
alphameric sequence, of all part numbers appearing in
authorized to remove, replace, and use the support item.
the listings. National stock numbers and part numbers
The maintenance code entered in the third position will
are cross-referenced to each illustration figure and item
indicate one of the following levels of maintenance:
number appearance.
Code
Application/Explanation
3. Explanation of Columns
O-
Support item is removed, replaced, used at the
a. Illustration This column is divided as follows:
organizational level.
(1) Figure number.
Indicates the figure
F-
Support item is removed, replaced, used at the
number of the illustration on which the
direct support level.
item is shown.
D-
Support items that are removed, replaced, used
(2) Item number. The number used to identify
at depot, mobile depot, specialized repair
item called out in the illustration.
activity only.
b. Source, Maintenance, and Recoverability (SMR)
(b) The maintenance code entered in the
Codes.
fourth position indicates whether the item is to be
(1) Source code. Source codes indicated the
repaired and identifies the lowest maintenance level with
manner of acquiring support items for
the capability to perform complete repair (i.e., all
maintenance, repair, or overhaul of end
authorized maintenance functions). This position will
items. Source codes are entered in the
contain one of the following maintenance codes:
first and second positions of the Uniform
SMR Code format as follows:
Code
Definition
PA-
Item procured and stocked for anticipated or
known usage.
1
