SECTION I
TM 11-6140-203-34P-3
INTRODUCTION
1. Scope
This manual lists spares and repair parts; special tools; special test, measurement, and diagnostic equipment
(TMDE), and other special support equipment required for performance of direct support and general support
maintenance of the BB-422/U, BB-651/UIH6(V), BB-429/U, BB-501/U, BB-693/U, and BB-651/U. It authorizes
the requisitioning and issue of spares and repair parts as indicated by the source and maintenance codes.
2. General
This Repair Parts and Special Tools List is divided into the following sections:
a. Section II. Repair Parts List. A list of spares and repair parts authorized for use in the performance of
maintenance. The list also includes parts which must be removed for replacement of the authorized parts.
Parts lists are composed of functional groups in numeric sequence, with the parts in each group listed in figure
and item number sequence.
b. Section III. Special Tools List. Not applicable.
number (NIIN) sequence, of all National stock numbers (NSN) appearing in the listings, followed by a list, in
alphameric sequence, of all part numbers appearing in the listings. National stock numbers and part numbers
are cross-referenced to each illustration figure and item number appearance.
3. Explanation of Columns
a. Illustration. This column is divided as follows:
(1) Figure number. Indicates the figure number of the illustration on which the item is shown.
(2) Item number. The number used to identify item called out in the illustration.
b. Source, Maintenance, and Recoverability (SMR) Codes.
(1) Source code. Source codes indicate the manner of acquiring support items for maintenance, repair,
or overhaul of end items. Source codes are entered in the first and second positions of the Uniform SMR Code
format as follows:
Code
Definition
PA -
Item procured and stocked for anticipated or known usage.
XD -
A support item that is not stocked. When required, item will be procured through normal supply
channels.
NOTE
Cannibalization or salvage may be used as a source of supply for any items
source coded above except those coded XA and aircraft support items as
restricted by AR 700-42.
(2) Maintenance code. Maintenance codes are assigned to indicate the levels of maintenance
authorized to USE and REPAIR support items. The maintenance codes are entered in the third and fourth
positions of the Uniform SMR Code format as follows:
(a) The maintenance code entered in the third position will indicate the lowest maintenance level
authorized to remove, replace, and use the support item. The maintenance code entered in the third position
will indicate one of the following levels of maintenance:
Code
Application/Explanation
O-
Support item is removed, replaced, used at the organizational level.
F-
Support item is removed, replaced, used at the direct support level.
(b) The maintenance code entered in the fourth position indicates whether the item is to be repaired and
identifies the lowest maintenance level with the capability to perform complete repair (i.e., all authorized
maintenance functions). This position will contain one of the following maintenance codes:
Code
Application/Explanation
F-
The lowest maintenance level capable of complete repair of the support item is the direct support
level.
Z-
Nonreparable. No repair is authorized.
(3) Recoverability code. Recoverability codes are assigned to support items to indicate the disposition
action on unserviceable items. The recoverability code is entered in the fifth position of the Uniform SMR Code
format as follows:
Recoverability
codes
Definition
Z-
Nonreparable item. When unserviceable, condemn and dispose at the level indicated in position 3.
A-
Item requires special handling or condemnation procedures because of specific reasons (i.e.,
precious metal content, high dollar value, critical material or hazardous material). Refer to appropriate
manuals/directives for specific instructions.
c. National Stock Number. Indicate the National
Change 1
1
