TM 9-6140-200-14
NOTE
If a higher rate of charge is desired, turn the AMPS Charge
Switch to the appropriate 2,3 or Hi position. Always return
the AMPs Charge switch to LO position before advancing
the volts charge switch.
Prepare batteries for charging in vehicle:
1. Inspect and Test Batteries (see para.3-7).
2. Make sure all accessories are turned off in the vehicle.
3. Plug in NATO Slave into vehicle receptacle
4. Plug charger in and check Stop/Go Light on charger if light is green charger is
connected correct.
5. Set charger (see para. 3-16) to charge batteries and read battery charger
instruction issued with equipment.
6. After charging disconnect battery charger in reverse order.
3-35
