TM 11-6130-392-20P
INTRODUCTION
codes are entered in the first and second positions
1. Scope
of the Uniform SMR Code format as follows:
This manual lists spares and repair parts; special
Definition
Code
tools; special test, measurement, and diagnostic
PA--Item procured and stocked for anticipated or
equipment (TMDE), and other special support
known usage.
equipment required for performance of organiza-
tional maintenance of the PP-7286/U. It authorizes
NOTE
the requisitioning and issue of spares and repair
Cannibalization or salvage may be used as
parts as indicated by the source and maintenance
a source of supply for any items source
codes.
coded above except those coded XA and
aircraft support items as restricted by AR
2. General
700-42.
This Repair Parts and Special Tools list is divided
(2) Maintenance code. Maintenance codes are
into the following sections:
assigned to indicate the levels of maintenance au-
thorized to USE and REPAIR support items. The
maintenance codes are entered in the third and
and repair parts authorized for use in the perform-
fourth positions of the Uniform SMR Code format
ance of maintenance. The list also includes parts
as follows:
which must be removed for replacement of the au-
thorized parts. Parts lists are composed of func-
(a) The maintenance code entered in the
third position will indicate the lowest maintenance
tional groups in numeric sequence, with the parts
in each group listed in figure and item number
level authorized to remove, replace, and use the
support item. The maintenance code entered in the
sequence.
third position will indicate one of the following
b. Section III. Special Tools List. Not appli-
levels of maintenance:
cable.
Application/Explanation
Code
C--Crew or operator maintenance performed
Number Index. A list, in National item identifica-
within organizational maintenance.
tion number (NIIN) sequence, of all National stock
O--Support item is removed, replaced, used at the
numbers (NSN) appearing in the listings, followed
organizational level.
by a list, in alphameric sequence, of all part num-
(b) The maintenance code entered in the
bers appearing in the listings. National stock num-
fourth position indicates whether the item is to be
bers and part numbers are cross-referenced to each
repaired and identifies the lowest maintenance
illustration figure and item number appearance.
level with the capability to perform complete repair
(i.e., all authorized maintenance functions). This
3. Explanation of Columns
position will contain one of the following mainte-
a. Illustration. This column is divided as follows:
nance codes:
(1) Figure number. Indicates the figure
Application/Explanation
Code
number of the illustration on which the item is
Z--Nonreparable. No repair is authorized.
shown.
(3) Recoverability code. Recoverability codes
(2) Item number. The number used to identify
are assigned to support items to indicate the dispo-
item called out in the illustration.
sition action on unserviceable items. The recovera-
bility code is entered in the fifth position of the
b. Source, Maintenance, and Recoverability
Uniform SMR Code format as follows:
(SMR) Codes.
(1) Source code. Source codes indicate the
Recoverability
manner of acquiring support items for mainte-
Definition
codes
Z--Nonreparable item. When unserviceable, con-
nance, repair, or overhaul of end items. Source
1