TM 11-6130-392-34P
INTRODUCTION
1. Scope
code
Definition
This manual lists spares and repair parts; special
PA - Item procured and stocked for anticipated or
tools; special test, measurement, and diagnostic
known usage.
equipment (TMDE), and other special support
PB - Item procured and stocked for insurance pur-
equipment required for performance of direct sup-
pose because essentiality dictates that a
port, and general support maintenance of the
minimum quantity be available in the sup-
PP-7286/U.
ply system.
It authorizes the requisitioning and issue of spares
PE - Support equipment procured and stocked for
and repair parts as indicated by the source and
initial issue or outfitting to specified main-
maintenance codes.
tenance repair activities.
XD - A support item that is not stocked. When
2. General
required, item will be procured through nor-
This Repair Parts and Special Tools List is divided
mal supply channels.
into the following sections:
NOTE
Cannibalization or salvage may be used
and repair parts authorized for use in the per-
as a source of supply for any items source
formance of maintenance. The list also includes
coded above except those coded XA and
parts which must be removed for replacement of
aircraft support items as restricted by
the authorized parts. Parts lists are composed of
AR 700-42.
functional groups in numeric sequence, with the
(2) Maintenance code. Maintenance codes are
parts in each group listed in figure and item num-
assigned to indicate the levels of maintenance
ber sequence.
authorized to USE and REPAIR support items. The
b. Section III. Special Tools List. A list of special
maintenance codes are entered in the third and four-
tools, special TMDE, and other special support
th positions of the Uniform SMR Code format as
equipment authorized for the performance of main-
follows:
tenance.
(a) The maintenance code entered in the third
c. Section IV. National Stock Number and Part
position will indicate the lowest maintenance level
Number Index. A list, in National item iden-
authorized to remove, replace, and use the support
tification number (NIIN) sequence, of all National
item. The maintenance code entered in the third
stock numbers (NSN) appearing in the listings,
position will indicate one of the following levels of
followed by a list, in alphameric sequence, of all part
maintenance:
numbers appearing in the listings. National stock
Code
Application/Explanation
numbers and part numbers are cross-referenced to
C - Crew or operator maintenance performed within
each illustration figure and item number ap-
organizational maintenance.
pearance.
O - Support item is removed, replaced, used at the
organizational level.
3. Explanation of Columns
F - Support item is removed, replaced, used at the
a. Illustration. This column is divided as follows:
direct support level.
(1) Figure number. Indicates the figure number
H - Support item is removed, replaced, used at the
of the illustration on which the item is shown.
general support level.
(2) Item number. The number used to identify
D - Support items that are removed, replaced, used
item called out in the illustration.
at depot, mobile depot, specialized repair ac-
b. Source, Maintenance, and Recoverability
tivity only.
(SMR) Codes.
(b) The maintenance code entered in the four-
(1) Source code. Source codes indicate the man-
th position indicates whether the item is to be
ner of acquiring support items for maintenance,
repaired and identifies the lowest maintenance level
repair, or overhaul of end items. Source codes are en-
with the capability to perform complete repair (i.e.,
tered in the first and second positions of the
all authorized maintenance functions). This postion
Uniform SMR Code format as follows:
will contain one of the following maintenance codes:
