TM 11-6140-203-14-4&P
specifies, by the listing of a "work time" figure in the
alphabetic code which leads to the remark in section IV,
appropriate subcolumn(s), the lowest level of
Remarks, which is pertinent to the item opposite the
maintenance authorized to perform the function listed in
particular code.
column 3. This figure represents the active time
required to perform that maintenance function at the
D-4.
Tool and Test Equipment Requirements
indicated category of maintenance. If the number or
(Sect. III)
complexity of the tasks within the listed maintenance
function vary at different maintenance
categories,
a. Tool or Test Equipment Reference Code. The
appropriate "work time" figures will be shown for each
numbers in this column coincide with the numbers used
category. The number of task-hours specified by the
in the tools and equipment column of the MAC. The
"work item" figure represents the average time required
numbers indicate the applicable tool or test equipment
to restore an item (assembly,
subassembly,
for the maintenance functions.
component, module, end item or
system) to a
b. Maintenance Category.
The codes in this
serviceable condition under typical
field operating
column indicate the maintenance category allocated the
conditions.
This time includes
preparation time,
tool or test equipment.
troubleshooting time, and quality
assurance/quality
c. Nomenclature.
This column lists the noun
control time in addition to the time required to perform
name and nomenclature of the tools and test equipment
the specific tasks identified for the maintenance
required to perform the maintenance functions.
functions authorized in the maintenance allocation chart.
d National/NATO Stock Number. This column
Subcolumns of column 4 are as follows:
lists the National/NATO stock number of the specific
C-Operator/Crew
tool or test equipment.
O-Organizational
e. Tool Number.
This column lists the
F-Direct Support
manufacturer's part number of the tool followed by the
H-General Support
Federal Supply Code for manufacturers (5-digit) in
D-Depot
parentheses.
e. Column 5, Tools and Equipment. Column 5
specifies by code, those common tool sets (not individual
D-5.
Remarks (Sect. IV)
tools) and special tools, test, and support equipment
required to perform the designated function
a. Reference Code.
This code refers to the
f Column 6, Remarks. Column 6 contains an
appropriate item in section II, column 6.
b. Remarks. This column provides the required
explanatory information necessary to clarify items
appearing in section II.
(Next printed page is D-3)
D-2
