TM 9-6140-200-14
NOTE
When replacing individual batteries, make sure
replacement batteries are at least the same electrical
capacity as the old battery or as the battery pairs
remaining in the equipment. Do not use any battery
showing average difference of more than 0.025 specific
gravity or 0.5 volt between other batteries used in the
equipment. Charge batteries that do not meet the
minimum requirement.
(1) Check that new battery is fully charged and that battery capacity equals
other batteries used in the equipment (Refer to Note above).
(2) Install battery (ies) make sure they are clean and free of dirt, grease,
corrosion, etc..
NOTE
Large batteries require two-man carry
(3) Use carrying strap (Item 18, Appx. B) when handling small batteries.
For large batteries use carrying handles build into the battery case or cover.
(4) Install Battery
(a) Place battery in the battery tray or box carefully. Make sure battery is in
a level position in the tray or box.
(b) Make sure positive battery cable is in same location as old battery cable
when battery was removed.
(c) Fasten battery securely with battery hold downs.
(d) Tighten fasteners of the battery hold downs evenly a little at a time, first
one side and then the other to prevent cracking of the battery case until
the battery is securely seated. If one battery hold down is fixed type,
make sure battery is securely seated before any pressure is applied to
the moveable side. Do not over tighten hold downs.
3-21
