TB 9-2320-280-35-9
NOTE
Remove left rear side rail, if necessary. (Refer to
TM 9-2320-280-20.)
Rear edge of upper mounting plate should be approximately
1.187 in. from front edge of EPLRS mounting plate.
16-3. Locate screw (7) on left rear wheelwell (11), and drill out rivet (8) from left rear wheelwell (11).
Enlarge hole to 0.281 in.
16-4. Position support plate underneath wheelwell (11) and drill two 0.281-in. diameter holes.
16-5. Using upper antenna plate (6) as template, locate, mark, and drill nine 0.281-in. holes (9) and three
0.408-in. holes (10) in left rear wheelwell (11).
6
EPLRS MOUNTING PLATE
9
11
9.75
10
9
9
8
7
6. ANTENNA PLATE A3104004-1 QTY. 1
Figure 5-36.
5-30
