TB 9-2320-280-35-9
NOTE
Perform step 16-10 only if not installing cargo soft-top enclosure;
otherwise, start with step 16-11.
16-10. Install antenna (31) on antenna mount assembly (14) with four capscrews (24), gasket (30), eight
lockwashers (25), and four nuts (26).
NOTE
Perform steps 16-11 through 16-12 only when installing cargo soft-
top enclosure.
16-11. Install cargo soft-top enclosure (32). (Refer to TM 9-2320-280-10.)
NOTE
Ensure all slack has been taken out of cargo soft-top enclosure, and
that cargo soft-top enclosure has been properly installed.
16-12. Using antenna (31) as template, locate, mark, and drill four 0.375-in. holes (33) and cut "X" (34) in
cargo soft-top enclosure (32).
16-13. Install antenna (31) on antenna mount assembly (14) and cargo soft-top enclosure (32) with four
capscrews (24), gasket (30), eight lockwashers (25), and four nuts (26), ensuring that ground
strap (27) is inserted through cut hole (34).
16-14. Install ground strap (27) on antenna mount assembly (14) with screw (29), three lockwashers (28),
and nut (19).
16-15. Tighten all nuts (19) and (26).
24
25
31
24
25
30
31
32
~
30
34
25
14
25
26
33
27
26
27
28
29
19
19.
NUT 9419143 QTY. 1
24.
CAPSCREW B1821BH038C150N QTY. 4
28
25.
LOCKWASHER MS45904-76 QTY. 8
26.
NUT 13218E0320-293 QTY. 4
27.
GROUND STRAP QTY. 1
28.
LOCKWASHER MS45904-68 QTY. 3
29.
CAPSCREW B1821BH025C075N QTY. 1
30.
GASKET A3013655-1 QTY. 1
31.
ANTENNA A3005031 QTY. 1
Figure 5-38.
5-32
