TM 9-6140-200-14
(4) Recheck the battery electrolyte for specific gravity and temperature.
(5) Note the difference in readings between steps (2) and (4) above.
(6) Charge battery to a fully charged state.
4-10. Placing Dry-Charged Battery in Service.
NOTE
This is a dry-charged, lead-acid battery. When placing
into service, identify the "in-service" Month/Year by
removing the proper tabs from the permanent label on
the top of the battery.
CAUTION
Do not remove sealing devices until ready to fill battery.
a. Remove and dispose of any sealing devices which seal each of the battery
cells during shipment and storage.
b. Remove vent caps and fill each cell with the over-packed electrolyte (only) to
the bottom of cell opening. Temperature of the battery and electrolyte must be
above 60 degrees F. (15.5 C), but preferably not above 100 degrees F (37.8
C.).
c. After filling to the proper level, allow the battery to stand for at least 2 hours
(required), or 24 hours (preferred/recommended). Check and record
electrolyte specific gravity of each cell, correcting the reading to 80 degrees F
(26.7 C.).
d. Add electrolyte, if necessary, to bring fluid level in each cell to the proper,
indicated level.
NOTE
After filling battery, install and finger tighten vent/filler caps.
Rinse container at once but it is desired rinse three times with
baking soda and water. You may dispose of as trash.
4-16
