TB 9-2320-280-35-10
Section XXIV. SINCGARS CABLES INSTALLATION
NOTE
This procedure applies to vehicles without existing antennas. For
vehicles with existing antennas, remove all control cables. (Refer
to TM 9-2320-280-20.)
Previously routed cables have been removed from figure 5-68 for
clarity.
24-1. Route antenna cable (7) from left side of mounting base (1), down through center access hole (4),
under integrated rack (5), and under right-side tunnel insulation (8) towards rear of vehicle.
24-2. Route antenna cable (9) from mounting base (1) to MT-6353/VRC mounting base (11).
24-3. Route power amp cable (2) from MT-6353/VRC mounting base (11), up through center access
hole (4), and connect power amp cable (2) to connector on W1J1 cable (2.1).
24-4. Route control cable (3) from MT-6353/VRC mounting base (11), up through center access hole (4), to
mounting base (1).
integrated rack (5).
2.1 3
2
1
4
~
6
5
11
3
2
10
9
6
7
~
8
6. ANTENNA CABLE A3014031-17 QTY. 1
7. ANTENNA CABLE A3014031-8 QTY. 1
9. ANTENNA CABLE A3014032-3 QTY. 1
Change 1
