TB 9-2320-280-35-10
26-19. Locate, mark, and drill one 0.147-in. hole (35) in top of windshield frame (30).
26-20. Route PLGR antenna cable (9) on top of windshield frame (30) and secure with loop clamp (26) and
self-tapping screw (25).
26-21. Route PLGR antenna cable (9) down through center access hole (29) of integrated rack (31), and coil
excess antenna cable (9) under integrated rack (31).
26-22. Route PLGR power cable (33) from PLGR installation mount (32) to right-side tunnel
insulation (34).
NOTE
Loosen right-side tunnel insulation before performing step 26-23.
(Refer to TM 9-2320-280-20.)
26-23. Route PLGR power cable (33) under edge of right-side tunnel insulation (34) to 24V terminal bar at
cab enclosure panel.
25
26
9
30
29
31
~
35
34
32
33
25. SELF-TAPPING SCREW 9421073 QTY. 1
26. LOOP CLAMP MS21333-65 QTY. 1
33. PLGR POWER CABLE 9728558-10 QTY. 1
Change 1
5-59
