TB 9-2320-280-35-9
Section XXII. PLGR ANTENNA AND CABLE INSTALLATION (WITHOUT BOLT-ON ARMOR)
NOTE
Perform this procedure only when installing additional PLGR
antenna when MTS is installed.
Drilled holes on inside and outside of windshield frame should
align to allow routing of PLGR cable through windshield frame.
Relocate all caution labels as necessary.
22-1. Using PLGR antenna mount bracket as template, locate, mark, and drill two 0.50-in. holes (3) in
outer windshield frame (1).
22-2. Locate, mark, and drill one 0.375-in. diameter hole (2) in outer windshield frame (1).
2
1
3
3
0.75
3.00
Figure 5-55.
22-3. Locate, mark, and drill one 0.375-in. diameter hole (4) in left-side inner windshield frame (5).
4
5
1.25
~
5.12
Figure 5-56.
Change 1
