TB 9-2320-280-35-9
Section XX. SINCGARS ANTENNA CABLES INSTALLATION
NOTE
Loosen left- and right-side tunnel insulation.
(Refer to TM 9-2320-280-20.)
20-1. Route antenna cable (1) from left side of mounting base (11) and power cable (2) from mounting
base (11), down through center access hole (4), under integrated rack (5), and under right-side
tunnel insulation (7) towards rear of vehicle.
20-2. Route antenna cable (10) from mounting base (11) to MT-6353/VRC mounting base (9).
20-3. Route power amp cable (3) from MT-6353/VRC mounting base (9), up through center access
hole (4), and connect power amp cable (3) to connector on W1J1 cable (3.1).
20-4. Route control cable (8) from MT-6353/VRC mounting base (9), up through center access hole (4), to
mounting base (11).
20-5. Route antenna cable (6) from front of MT-6353/VRC mounting base (9), under integrated rack (5),
and under right-side tunnel insulation (7) towards rear of vehicle.
3.1
3
2
1
4
5
11
10
6
~
1
2
7
9
8
1.
ANTENNA CABLE A3014031-8 QTY. 1
2.
SINCGARS POWER CABLE A3014039-2 QTY. 1
6.
ANTENNA CABLE A3014031-17 QTY. 1
10.
ANTENNA CABLE A3014032-3 QTY. 1
Figure 5-50.
Change 1
