TB 9-2320-280-35-9
NOTE
Perform step 25-15 for vehicles with left rear cab enclosure panel
only.
25-4. Cut 2x2 in. section (13) from left rear cab enclosure panel (11). Install grommet (12). Reinstall cab
enclosure panel (11). (Refer to TM 9-2320-280-20.)
25-5. Locate, mark, and drill three 0.147-in. holes (8) along tunnel edge (9).
25-6. Route INC-EPUU cable (1) and power cable (4) rearward under left-side B-beam (10) and along
tunnel edge (9).
25-7. Route INC-EPUU cable (1) and power cable (4) rearward along tunnel edge (9) and secure with
three clamps (7) and self-tapping screws (6).
5-56
