TB 9-2320-280-35-9
25-18. Locate, mark, and drill one 0.225-in. hole (22) in inboard corner on rear inside lip of left rear seat
back support (19).
25-19. Locate, mark, and drill two 0.147-in. holes (24) in front face of left rear wheelwell (34).
25-20. Route EPLRS antenna cable (16) along rear perimeter of left rear seat back support (19), up front
face of left rear wheelwell (34), and up antenna base (35).
NOTE
Clamps are large to accommodate black charger cable from power
entry box in step 25-20.
25-21. Secure EPLRS antenna cable (16) to seat back support (19) with screw (23), lockwasher (21),
nut (20), two self-tapping screws (18), two existing screws (14), and five loop clamps (15).
25-22. Secure antenna cable (16) to antenna base (35) with clamps (29), existing screws (25), washers (26),
lockwashers (27), and nuts (28).
25-23. Connect antenna cable (16) to antenna (31). Route antenna cable (16) through multi-net rack (33) to
vicinity of EPLRS mount.
25-24. Tighten all screws and nuts on all clamps.
25-25. Secure right-side tunnel insulation. (Refer to TM 9-2320-280-20.)
5-60
