TB 9-2320-280-35-9
25-8. Locate, mark, and drill one 0.225-in. hole (22) in inboard corner on rear inside lip of left rear seat
back support (19).
25-9. Locate, mark, and drill two 0.147-in. holes (24) in front face of left rear wheelwell (17).
25-10. Route cables (16), (1), and (4) along rear perimeter of left rear seat back support (19), up front face
of left rear wheelwell (17), and under antenna base (30).
25-11. Secure cables (16), (1), and (4) to left rear wheelwell (17) with screw (23), lockwasher (21), nut (20),
two self-tapping screws (18), two existing screws (14), and five loop clamps (15).
25-12. Route cables (1) and (4) to EPLRS mount (32)
25-13. Secure antenna cable (16) to antenna base (30) with existing loop clamps (29), screws (25),
washers (26), lockwashers (27), and nuts (28).
25-15. Take all slack out of cable and store under EPLRS mount assembly.
25-16. Tighten all screws and nuts on all clamps.
25-17. Secure right-side tunnel insulation. (Refer to TM 9-2320-280-20.)
5-58
