TM 11-6130-413-12
Control or Indicator
Function
Control or Indicator
Function
timer (Ml) is operating.
matic charging; or for manual
Powercord(P3) . . . . . . . . . . . . . P r o v i d e s connection to local
charging.
power source.
Run indicator (DSl). . . . . . . . . . Amber lamp indicates the
Battery connector (J5) . . . . . . . Provides connection to battery.
AUTO/MAN CHARGE No. 2
Section II. OPERATION UNDER USUAL AND UNUSUAL CONDITIONS
CAUTION
3-3. Operating Procedures
Before you connect any nickel-cadmium bat-
The following are the complete normal operating
tery to the charger/analyzer, determine the
procedures. For operational checkout procedures after
correct charge/discharge rates and safety pre-
installation, servicing or as a periodic check, refer to
cautions by referring to the appropriate bat-
paragraph 4-8. Connect dc output connector J5 to the
tery manual (TM 11-6140-203-14-2, TM
known good battery, connect ac connector P3 to the lo-
11-6140-203-14-3, or TM 11-6140-203-
cal ac power source, then perform the following pro-
15-1).
cedures:
Figure 3-1. Controls and Indicators.
3-2
