TM5-6130-301-13&P
(b) Remove screws securing receptacle assembly (13) to panel.
(c) Disconnect receptacle leads from ground bus bar and associated circuit breaker.
(d) Remove receptacle assembly from panel.
NOTE
Remove attaching hardware from heat sink bridges
and from the bus bars, if applicable, to receptacle
assembly being removed.
(6) Diode.
(a) Loosen panel fastener screws (1) and open panel.
(b) Remove receptacle power lead from diode (14).
(c) Remove diode.
NOTE
Remove attaching hardware from heat sinks (10) and
remove heat sinks as necessary.
1.
Panel Fasteners Screw
7.
Bus Bar Connectors
13. Receptacle
2.
Panel
8.
Bus Bar Jumper
14. Diode
3.
Meter
9.
Circuit Breaker Boot
15. Relay, 200 Amp
4.
Bus Bar Supports
16. Toggle Switch
10. Attaching Hardware
5.
Bus Bar
17. Control Knob
11. Bus Bar Ground
6.
Circuit Breakers
18. Bus Bar
12. Circuit Breaker, 20 Amp
19. Resistor
