TM 5-6130-301-13&P
DIRECT SUPPORT MAINTENANCE
Section I. TROUBLESHOOTING PROCEDURE
5-1. GENERAL
a. Scope. This section contains troubleshooting information for locating some of the troubles that may develop
in the battery charging distribution panel. Each malfunction or symptom of trouble given is followed by a list of
probable causes or tests, and corrective action to remedy the malfunction.
b. Method. This techical manual cannot cover all possible troubles and deficiencies that may occur under the
many conditions of operation. If a specific trouble test, or remedy is not covered, isolate the system in which the
trouble occurs, and then locate the defective component.
c. Maintenance Level. The tests and remedies in this section are governed by the direct support level of
maintenance.
MALFUNCTION
PROBABLE CAUSE
CORRECTIVE ACTION
Check wires for continuity with ohmmeter.
Repare or replace defective wires.
Replace wiring harness.
2. CABLE ASSEMBLIES FAULTY
Check wires for continuity with ohmmeter.
Repair or replace defective wires.
Replace defective connectors.
Section II. MAINTENANCE PROCEDURES
5-2. GENERAL. Disassembly and reassembly for most of the components of the Battery Charger Distribution
Panel generally involves no more than removal of attached hardware, and lifting or sliding the component from
the panel.
a. Disassembly. (Figure 5-1)
(1) Boat, circuit breaker. Remove two phillips head screws that secure circuit breaker boot (9) and
retaining plate and remove circuit breaker boot.
